Avmap APRS Instrukcja Użytkownika Pobierz pdf (Strona 21)

Set-up for the Kenwood TH-D72A/E

with the AvMap Geosat 6 APRS

These instructions provide the essential information

necessary to congure your AvMap Geosat 6 APRS and

your Kenwood TH-D72A/E HT for basic APRS operation.

After you have achieved basic operation and have some

experience with the system, you will want to adjust

various parameters to more closely meet your particular

environment and operating requirements.

Note: These instructions assume you have basic operating knowledge

of both the AvMap Geosat 6 APRS and the Kenwood TH-D72A/E. They

also assume that both units are at factory default settings. If you

have problems getting the system to work, return both units to

factory default. Perform these instructions, and then reset any

other settings to your preference. Do not connect the two units

until the conguration of both units has been completed.

Kenwood TH-D72A/E Radio Setup

• Turn the TH-D72A/E ON.

• Press the F button.

• Use the up/down/OK/Esc control to select and set

the following functions:

- F-1 – Int. GPS – Off

- F-7 – Voice Alert – Off

• Press Esc to exit the function menu.

• Use the A/B button to select the desired radio side

for APRS.

• Press the VFO button and adjust the frequency to

your standard APRS frequency (144.39MHz in the US).

• If necessary, press F-Shift to remove + and – from the

display.

• If necessary, press Tone to remove the T, CT, DCS,

and D/O icons from the display. The icon position

should be blank.

• Press Menu button and set or verify the menu

APRS functions

AvMap - 21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Brak uwag

Avmap APRS Instrukcja Użytkownika Strona 21