Avmap APRS Instrukcja Użytkownika Pobierz pdf (Strona 25)

3. Turn on the Geosat G6 APRS and the TH-D72A/E.

Wait until the Geosat 6 APRS has acquired sufcient

satellites to establish a 3D position. A blinking GPS

icon (not iGPS) should then appear in the upper right

corner of TH-D72A/E display.

4. Set the volume at about 1/3 volume. If there is

APRS activity in your area, you should here the brief

“growl” of packet transmissions. You will hear a short

beep when you receive an APRS signal, a longer beep

when you transmit your position, and a double (high-

low) beep when you receive your position back from

a digipeater.

Now that you have a working system, you will want

to decrease your beacon rate, and change other set-

tings according to your desired operating method.

Read the APRS section of the Kenwood TH-D72A/E CD

manual. This manual provides additional information

on the functions of the various APRS controls, and

how to set them for your desired operating condi-

tions.

Troubleshooting

If you do not see a ashing “GPS” signal on the upper

right hand corner of the TH-D72A/E, or APRS stations

are not appearing in the APRS Contacts list on the

Geosat 6 APRS, then the data cable may not be fully

or correctly seated.

1. Remove one plug and assure that it is the correct

plug for that unit and is plugged into the correct port,

according to the description in the previous section

of these instructions. Return the plug to the proper

port and rmly push it in.

2. Check that the cord at the other end is in the cor-

rect port and rmly press on the plug to assure it is

properly seated.

3.Check the cord for continuity and no shorts, using

APRS functions

AvMap - 25

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Brak uwag

Avmap APRS Instrukcja Użytkownika Strona 25