Avmap APRS Instrukcja Użytkownika Pobierz pdf (Strona 30)

Set-up for Kenwood TM-D700 A/E

with the AvMap Geosat 6 APRS

NOTE: These instructions assume you have basic familiarity with

operation of both the TH-D700 A/E

and the AvMap Geosat 6 APRS .

a. While programming the Kenwood TM-D700 and/or

the AvMap Geosat 6 APRS , the communication cable

should be disconnected. Strange and/or bad things can

occur if you fail to head this warning!

b. Starting with the Kenwood TM-D700. Note: Items in

[ ] are buttons and { } are items you enter and/or ‘see’

on the radio screen.

c. Turn on the radio.

d. Make sure that {T}, {CT} and {DCS} do not appear at

the top of your Kenwood TM-D700 screen, if they do

press the [TONE] button until none of these appear.

e. Press the menu button [MNU] and use the control

knob to get to the APRS setup menu {APRS

3-X} (the X here can be any letter or number) and

press the [OK] button to select/enter.

f. Use the [é] and [ê] buttons to go to different

screens in the APRS menu and the [OK] button to

select/enter that particular screen.

g. Once you make your selection and/or entry push

the [OK] button again to save the selection/entry.

Then go back to ‘f.’ above to get to the next APRS

screen and enter all the Table 1 settings below.

h. Press the [ESC] button to leave the APRS setup

screen and return the D700 user screen.

i. You can now power down the radio and it will keep

your settings.

APRS Functions

30 - AvMap

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Brak uwag

Avmap APRS Instrukcja Użytkownika Strona 30