Avmap APRS Instrukcja Użytkownika Pobierz pdf (Strona 28)

Beacon TX Algorithm Menu # 611

a. Set the Method to “smart beacon”

b. Press ESC to return to the main page

c. Change the APRS Frequency to: 144.390

d. Select TNC and press to turn on APRS 12

e. Press “BCON” to turn on -- BCON will appear in the

upper right corner The Kenwood Radio is now ready to

interface with the Geosat 6 APRS .

Making it all work!

a. Make sure both the Kenwood TM-D710 and AvMap

Geosat 6 APRS are turned OFF!

b. Connect the four pole 2.5mm communication cable

end to theserial port of the Geosat 6 APRS (show picture

of Geosat 6 serial port) and the three pole 2.5 mm end

to the D710’s GPS receptacle. IMPORTANT! These are

easily reversed and hooked up backwards…also…when

connecting to the Geosat 6 APRS make sure you plug

into the serial input…not audio input.

Check for a good click into the unit.

c. NOW POWER UP BOTH UNITS!

CAUTION!

If you interface the units and do not see a ashing “GPS”

signal on the upper right hand corner of the Kenwood,

then the APRS cable may not be plugged-in all the way

or correctly. Please check that the cord is plugged into

the proper ports and plugged-in all the way.

Also verify that the Geosat 6 APRS is receiving a GPS x.

Once your Geosat 6 APRS and radio are working properly

together, you will see an indication on the radio (if it

provides such) that it is receiving GPS position data.

In addition, as the radio provides position information

to the Geosat 6 APRS , stations will be plotted on

the screen. Depending upon the location of plotted

stations, you may need to expand the scale of the

APRS Functions

28 - AvMap

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Brak uwag

Avmap APRS Instrukcja Użytkownika Strona 28